Bicone Tutorial

 
For proper alignment, make sure that your bottom tray is loaded into the base with the X on the left side. When pressing, also make sure that the X on the top of the tool is towards the left.
 

 

Lay down your initial footprint approximately 1mm shy of the edges of the cavity on both sides.  Check the size by bringing the mandrel down to the tool for reference. 

Also, wind it on with enough glass to almost reach the bottom of the trough (this depends on how much decoration you are going to add -- if you are going to add a lot of decoration, it doesn’t need to reach the bottom yet).  If you've followed our tip about determining how much glass you need for the cavity, you will know about how much glass to wind onto your mandrel.

 

I like to finish my ends with a nice pucker before I add my designs by turning my mandrel at a 45 degree angle and heating the end of the bead so that it will flow down a bit and form the pucker. Next you should decorate your bead and when melting your design in, heat, roll on a marver, heat, roll on the marver to slowly melt the design smooth. This helps to ensure that the design doesn't smear.
 
Now for the rolling step…I make sure the bead is balanced (i.e. the bead is the same width on all sides of the mandrel) heat the bead to a slight glow and then wait for it to just stop glowing and then roll VERY gently the first time. If you roll when it is too hot, it can take your bead out of balance. This first roll will just slightly change the shape. Make sure that you have the mandrel in a perfectly horizontal position so that neither end is up higher than the other and also that your bead is centered between the 2 sides. Then heat each side of the bicone and roll again. Heat and roll until you achieve your desired bicone shape. Lightly heat the bead to remove any chill marks and pop it in the kiln.

* The nice thing about this tool is that depending on the amount of glass you initially wind on to your mandrel, you can achieve a nice slim bicone or a chunky one. 

 

 

beads by Gina Beardsley


Always FREE Shipping

© 2005 & 2006 CattWalk™ - All rights reserved
CattWalk™ - 20 West River Styx Road - Hopatcong, New Jersey 07843-1828
(973)398-7390 office or (843)834-1229 cell

Website maintained by: WhoDidItDesign.com